Cisco IE 3000 Hardware Installation Manual page 156
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Connecting Destination Ports
Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable
Caution
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in
the
"Preparing for Installation" section on page
information about the LC on the SFP module.
To connect to a dual-purpose port, follow these steps:
Connect an RJ-45 connector to the 10/100/1000 port, or install an SFP module into the SFP module slot,
Step 1
and connect a cable to the SFP module port. See
For more information about RJ-45 connections, SFP modules, and optical connections, see the
"Connecting to 10/100 and 10/100/1000 Ports" section on page
Transceivers" section on page
Figure B-36
1
LC connector
Step 2
Connect the other end of the cable to the other device.
By default, the switch detects whether an RJ-45 connector or SFP module is connected to a dual-purpose
port and configures the port accordingly. You can change this setting and configure the port to recognize
only an RJ-45 connector or only an SFP module by using the media type interface configuration
command. For more information, see the switch command reference.
Cisco IE 3000 Switch Hardware Installation Guide
B-50
B-45, and the
Connecting to a Dual-Purpose Port
1
2
2
RJ-45 connector
Appendix B
Installation In a Hazardous Environment
B-1. See
Appendix C, "Cable and Connectors,"
Figure
B-36.
B-44, the
"Connecting to SFP Transceivers" section on page
for
"Installing and Removing SFP
B-48.
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
