Connecting To 100Base-Fx Ports - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Appendix B
Installation In a Hazardous Environment
Connecting to 100BASE-FX Ports
Follow these steps to connect a fiber-optic cable to an Cisco IEM-3000-8FM expansion module:
Class 1 laser product. Statement 1008
Warning
Caution
Do not remove the rubber plugs from the SFF module port or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the SFF module ports and cables
from contamination and ambient light.
Before connecting to the SFF module, be sure that you understand the port and cabling stipulations in
the
"Preparing for Installation" section on page
on page C-5
Step 1
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Insert one end of the fiber-optic cable into the SFP module port. See
Step 2
Figure B-37
1
Insert the other cable end into a fiber-optic receptacle on a target device.
Step 3
Observe the port status LED.
Step 4
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This process
takes about 30 seconds, and then the port LED turns green.
for information about the LC connector on the SFP module.
Connecting to a Fiber-Optic SFP Module Port
1
LC connector
B-1. See the
"Cable and Adapter Specifications" section
Figure
Cisco IE 3000 Switch Hardware Installation Guide
Connecting Destination Ports
B-35.
B-51
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
