Cisco IE 3000 Hardware Installation Manual page 186

Hide thumbs Also See for IE 3000:

Table of Contents

Entering the Initial Configuration Information

interface FastEthernet1/1

interface FastEthernet1/2

interface FastEthernet1/3

...(output abbreviated)

interface GigabitEthernet1/1

interface GigabitEthernet1/2

end

These choices appear:

Step 10

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it

in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

After you complete the setup program, the switch can run the default configuration that you created. If

you want to change this configuration or want to perform other management tasks, use one of these tools:

Command-line interface (CLI)

•

Cisco Network Assistant (for one or more switches)

•

To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal

emulation program or through the network by using Telnet. For configuration information, see the switch

software configuration guide or the switch command reference.

To use the Cisco Network Assistant, see the Getting Started with Cisco Network Assistant guide on

Cisco.com.

Cisco IE 3000 Switch Hardware Installation Guide

D-4

Appendix D

Configuring the Switch with the CLI-Based Setup Program

Table of Contents

Show Quick Links

Table of Contents