Connecting To A Poe Port; Connecting The Switch To The Power Converter - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Connecting the Switch to the Power Converter
If an LED is off, the target device might not be turned on, there might be a cable problem, or there might
be a problem with the adapter installed in the target device. See
solutions to cabling problems.
If necessary, reconfigure and restart the switch or target device.
Step 5
Connecting to a PoE Port
The expansion module PoE ports support either the IEEE 802.3af standard (PoE), which provides up to
15.4 W of power per port (4 ports total), or the IEEE 802.3at standard (PoE+), which provides up to
30 W of power per port. To allow 4 PoE+ ports, the following command line is required when using over
65 W power input to the expansion module:
[power inline wattage <mod> max <4-130> watts]
Connecting the Switch to the Power Converter
The Cisco IE 3000 switch can be used with an optional AC/DC power converter (PWR-IE3000-AC).
These sections describe the steps required to connect the switch to a power converter:
•
•
•
•
•
•
Cisco IE 3000 Switch Hardware Installation Guide
2-48
Attaching the Power Converter to the Switch, page 2-49
Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter, page 2-50
Connecting the DC Power Clip, page 2-50
Connecting the Power Converter to an AC Power Source, page 2-51
Connecting the Power Converter to a DC Power Source, page 2-54
Applying Power to the Power Converter, page 2-56
Chapter 2
Switch Installation
Chapter 3, "Troubleshooting,"
for
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
