Attaching The Power Converter To The Switch - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Chapter 2
Switch Installation
Attaching the Power Converter to the Switch
To connect the power converter to the switch, follow these steps:
Remove the left side panel of the switch by firmly grasping both sides of it in the middle and pulling it
Step 1
outward. If necessary, use a screwdriver to open the side panel. See
Figure 2-38
Push the upper modules latches (at the top of the switch and the power converter) up and the lower
Step 2
module latches (at the bottom of the switch and the power converter) down. See
Figure 2-39
24V
, 2.1 A
Rtn Ou
t (-)
Pw r Ou
t (+)
DC OK
N /
L /
100 -240
V~, 50-6
125 -250
V
, 1.25 A
Opening the Left Side Panel of the Switch
Pushing the Module Latches Up and Positioning the Hardware
0Hz /
MA X
Connecting the Switch to the Power Converter
Figure
2-38.
Cisco IE 3000 Switch Hardware Installation Guide
Figure
2-39.
2-49
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
