Table of Contents
Advertisement
Rate Limit and Storm Control Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
The rate limit on a port does not calculate traffic controlled by storm control on this
port.
Use the no storm-control command to disable storm control of all traffic type on
the port.
You can use the following commands to reset an interface shut down by Storm
Control:
•
The
errdisable recovery reset
parameter to reset a given interface.
•
The
errdisable recovery cause
automatically recover from the Storm Control error-disabled state.
Example
The following example enables broadcast, multicast, and unicast unknown storm
control on port gi11 and multicast unregistered and unicast unknown on port gi12:
Enable group 1 for registered and unregistered multicast traffic on interface gi11.
Extra traffic is discarded.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config)#
switchxxxxxx(config-if)#
shutdown
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
command with the interface
with the storm-control parameter to
interface gi11
storm-control broadcast kbps 10000 shutdown
storm-control multicast level 20 trap
storm-control unicast level 5 trap shutdown
exit
interface gi12
storm-control multicast unregistered level 5 trap
storm-control unicast level 5 trap
exit
50
interface-id
1006
Advertisement
Table of Contents
