Table of Contents
Advertisement
57
1093
If a packet is mirrored by both the port-based ingress mirroring mechanism, and
one of the other ingress mirroring mechanisms, the selected session is the one
with the higher session number.
All definitions of different source ports for the same source session must be of the
same type: SPAN, start RSPAN start, or RSPAN final.
A source port cannot be a destination port.
The source interface in a RSPAN source switch can not be a membership of the
remote VLAN.
Use the no monitor session
vlan-id
} | {remote vlan
Use the no monitor session
sources ports of the given source session.
Example
Example 1. The following example configures a SPAN session consisting from 3
source and one destination session. The first source session copies traffic for both
directions from the source port
traffic from VLAN 100, and the third source session copies traffic for received on
the source port
3. The destination session defines port
gi1
destination port.
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
Example 2. The following example configures a RSPAN start session consisting
from 2 source and one destination sessions. The first source session copies traffic
for both directions from the source port
from VLAN 100. The destination session defines VLAN 2 as the RSPAN VLAN and
port
1 as the reflector port
gi1
switchxxxxxx(config)#
switchxxxxxx(config)#
session_number
vlan-id
} command to remove one source.
session_number
2, the second source session copies bridges
gi1
monitor session 1 source interface gi12 both
monitor session 1 source vlan 100
monitor session 1 source interface gi13 rx
monitor session 1 destination interface gi11
gi1
monitor session 1 source interface gi12 both
monitor session 1 source vlan 100
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
SPAN and RSPAN Commands
interface-id
source {interface
source command to remove all
gi11 as the
2 and the second session copies traffic
} | {vlan
Advertisement
Table of Contents
