Cisco Catalyst 2955 Hardware Installation Manual page 44
Cisco systems switch installation guide
Hide thumbs
Also See for Catalyst 2955:
- Installation notes (12 pages) ,
- Configuration manual (710 pages) ,
- Command reference manual (686 pages)
Table of Contents
Advertisement
Entering the Initial Configuration Information
!
end
These choices appear:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots,
save it in nonvolatile RAM (NVRAM) by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default
configuration that you created. If you want to change this configuration or want
to perform other management tasks, use one of these tools:
•
•
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal-emulation program or through the network by using Telnet.
For configuration information, see the switch software configuration guide or the
switch command reference.
To use the Network Assistant, see the Getting Started with Cisco Network
Assistant guide on Cisco.com.
Catalyst 2955 Hardware Installation Guide
1-10
Chapter 1
Command-line interface (CLI)
Network Assistant (for one or more switches)
Configuring the Switch with the CLI-Based Setup Program
78-14944-03
Hide quick links:
Advertisement
Table of Contents
