Cisco Catalyst 2955 Hardware Installation Manual page 76
Cisco systems switch installation guide
Hide thumbs
Also See for Catalyst 2955:
- Installation notes (12 pages) ,
- Configuration manual (710 pages) ,
- Command reference manual (686 pages)
Table of Contents
Advertisement
Verifying Switch Operation
The PC or terminal must support VT100 terminal emulation. The
terminal-emulation software—frequently a PC application such as
HyperTerminal or Procomm Plus—makes communication between the switch and
your PC or terminal possible during the setup program.
Follow these steps to connect the PC or terminal to the switch:
Make sure that your terminal-emulation software is configured to communicate
Step 1
with the switch through hardware flow control.
Configure the baud rate and data format of the PC or terminal to match these
Step 2
console-port default characteristics:
•
•
•
•
After gaining access to the switch, you can change the port baud rate. See the
switch software configuration guide for instructions.
Step 3
Insert the adapter cable in the console port, as shown in
"Cable and Adapter Pinouts" section on page B-9
Catalyst 2955 Hardware Installation Guide
3-12
9600 baud
Eight data bits
One stop bit
No parity
Chapter 3
Installation
Figure
3-1. (See the
for pinout descriptions.)
78-14944-03
Hide quick links:
Advertisement
Table of Contents
