Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch(config)# interface gigabitethernet 2/4 no shut
Step 2
Enable the SAN Extension Tuner; this is required for the network simulator tool to work.
switch(config)# feature san-ext-tuner
switch(config)# exit
Enable the network simulator on Gigabit Ethernet ports 2/3 and 2/4. Then check that the Gigabit Ethernet
Step 3
ports are operating in network simulation mode.
switch# ips netsim enable interface gigabitethernet 2/3 gigabitethernet 2/4
switch# show ips netsim
Following ports operate in network simulator mode
GigabitEthernet2/3 and GigabitEthernet2/4
Step 4
Configure a delay of 100 ms round trip (sum of both trips) for all the packets that are arriving on the
specified Gigabit Ethernet port.
switch# ips netsim delay-ms 50 ingress gigabitethernet 2/3
switch# ips netsim delay-ms 50 ingress gigabitethernet 2/4
Confirm that the delay you introduced is configured.
Step 5
switch# show ips stats netsim ingress gigabitethernet 2/3
Network Simulator Configuration for Ingress on GigabitEthernet2/3
Network Simulator Statistics for Ingress on GigabitEthernet2/3
Default Settings
Table 58-1
Table 58-1
Parameters
Timeout period to invoke fctrace
Number of frame sent by the fcping feature 5 frames
Remote capture connection protocol
Remote capture connection mode
Cisco MDS 9000 Family CLI Configuration Guide
58-30
Delay
: 50000 microseconds
Rate
: 1000000 kbps
Max_q
: 100000 bytes
Max_qdelay
: 600000 clocks
Dropped (tot)
= 0
Dropped
(ne)
= 0
Reordered (ne)
= 0
Max Qlen(pkt)
= 5
Qlen
(pkt)
= 0
Max Qlen (byte) = 0
Qlen
(byte) = 0
Mintxdel(poll)
= 128322
Mintxdel(ethtx) = 360
empty
= 9
txdel
= 0
late
= 7
Average speed
= 0 Kbps
lists the default settings for the features included in this chapter.
Default Settings for Fabric Troubleshooting Features
Chapter 58
Default
5 seconds
TCP
Passive
OL-18084-01, Cisco MDS NX-OS Release 4.x
Troubleshooting Your Fabric
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
