Advanced Fcip Profile Configuration; Configuring Tcp Listener Ports - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)

Hide thumbs Also See for AP776A - Nexus Converged Network Switch 5020:

Table of Contents

Configuring FCIP

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Advanced FCIP Profile Configuration

A basic FCIP configuration uses the local IP address to configure the FCIP profile. In addition to the

local IP address and the local port, you can specify other TCP parameters as part of the FCIP profile

configuration.

FCIP configuration options can be accessed from the switch(Config-profile)# submode prompt.

To configure TCP listener ports, follow these steps:

switch# config terminal

switch(config)#

switch(config)# fcip profile 20

switch(config-profile)#

The default TCP port for FCIP is 3225. You can change this port using the port command.

To change the default FCIP port number (3225), follow these steps:

switch(config-profile)# port 5000

switch(config-profile)# no port

Cisco MDS 9000 Family CLI Configuration Guide

Configuring TCP Listener Ports, page 41-12

Configuring TCP Parameters, page 41-13

Displaying FCIP Profile Configuration Information, page 41-17

Enters configuration mode.

Creates the profile (if it does not already exist) and enters profile

configuration submode. The valid range is from 1 to 255.

Associates the profile with the local port number (5000).

Reverts to the default 3225 port.

Configuring FCIP

OL-18084-01, Cisco MDS NX-OS Release 4.x

Show Quick Links

Table of Contents