Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 716
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
This setup utility will guide you through basic Ficon Configuration
on the system.
Press Enter if you want to skip any dialog. Use ctrl-c at anytime
to skip all remaining dialogs.
Enter yes (the default is yes) to enter the basic FICON configuration setup.
Step 2
Would you like to enter the basic configuration dialog (yes/no) [yes]: yes
The FICON setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt
to end the configuration process.
Step 3
Enter the VSAN number for which FICON should be enabled.
Enter vsan [1-4093]:2
Enter yes (the default is yes) to create a VSAN.
Step 4
vsan 2 does not exist, create it? (yes/no) [yes]: yes
Enter yes (the default is yes) to confirm your VSAN choice:
Step 5
Enable ficon on this vsan? (yes/no) [yes]: yes
Note
Enter the domain ID number for the specified FICON VSAN.
Step 6
Configure domain-id for this ficon vsan (1-239):2
Enter yes (the default is no) to set up FICON in cascaded mode. If you enter no, skip to
Step 7
"CUP In-Band Management" section on page
Would you like to configure ficon in cascaded mode: (yes/no) [no]: yes
a.
b.
c.
Enter yes (the default is yes) to allow SNMP permission to modify existing port connectivity parameters
Step 8
(see the
Enable SNMP to modify port connectivity parameters? (yes/no) [yes]: yes
Enter no (the default is no) to allow the host (mainframe) to modify the port connectivity parameters, if
Step 9
required (see the
Disable Host from modifying port connectivity parameters? (yes/no) [no]: no
Step 10
Enter yes (the default is yes) to enable the active equals saved feature (see the
the Running Configuration" section on page
Cisco MDS 9000 Family CLI Configuration Guide
29-16
--- Ficon Configuration Dialog ---
At this point, the software creates the VSAN if it does not already exist.
Assign the peer WWN for the FICON: CUP.
Configure peer wwn (hh:hh:hh:hh:hh:hh:hh:hh): 11:00:02:01:aa:bb:cc:00
Assign the peer domain ID for the FICON: CUP
Configure peer domain (1-239) :4
Enter yes if you wish to configure additional peers (and repeat Steps
wish to configure additional peers.
Would you like to configure additional peers: (yes/no) [no]: no
"Configuring SNMP Control of FICON Parameters" section on page
"Allowing the Host to Change FICON Port Parameters" section on page
29-40).
29-22).
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 29
Configuring FICON
Step 8
(see the
7a
and 7b). Enter no, if you do
29-21).
29-20).
"Automatically Saving
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
