About Sfp Transmitter Types - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Chapter 13
Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 2
switch(config)# no system default
switchport shutdown
switch(config)#
switch(config)# system default
switchport shutdown
switch(config)#
switch(config)# system default
switchport trunk mode auto
switch(config)#
About SFP Transmitter Types
The small form-factor pluggable (SFP) hardware transmitters are identified by their acronyms when
displayed in the show interface brief command. If the related SFP has a Cisco-assigned extended ID,
then the show interface and show interface brief commands display the ID instead of the transmitter
type. The show interface transceiver command and the show interface fcs lot/port transceiver
command display both values for Cisco-supported SFPs.
command output (see the
Table 13-5
Definition
Standard transmitters defined in the GBIC specifications
short wave laser
long wave laser
long wave laser cost reduced
electrical
Extended transmitters assigned to Cisco-supported SFPs
CWDM-1470
CWDM-1490
CWDM-1510
CWDM-1530
CWDM-1550
CWDM-1570
CWDM-1590
CWDM-1610
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Configures the default setting for administrative state of an
interface as Up. (The factory default setting is Down).
Tip
Configures the default setting for administrative state of an
interface as Down. This is the factory default setting.
Tip
Configures the default setting for administrative trunk mode
state of an interface as Auto.
Note
"Displaying Interface Information" section on page
SFP Transmitter Acronym Definitions
This command is applicable only to interfaces for
which no user configuration exists for the
administrative state.
This command is applicable only to interfaces for
which no user configuration exists for the
administrative state.
The default setting is trunk mode on.
Table 13-5
defines the acronyms used in the
Acronym
swl
lwl
lwcr
elec
c1470
c1490
c1510
c1530
c1550
c1570
c1590
c1610
Cisco MDS 9000 Family CLI Configuration Guide
Fibre Channel Interfaces
13-22).
13-21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
