Forcing Fabric Binding Activation; Saving Fabric Binding Configurations - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Chapter 40
Configuring Fabric Binding
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
By default, the fabric binding feature is not activated. You cannot activate the fabric binding database on
the switch if entries existing in the configured database conflict with the current state of the fabric. For
example, one of the already logged in switches may be denied login by the config-database. You can
choose to forcefully override these situations.
Note
After activation, any already logged in switch that violates the current active database will be logged out,
and all switches that were previously denied login because of fabric binding restrictions are reinitialized.
To activate the fabric binding feature, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fabric-binding activate vsan 10
switch(config)# no fabric-binding activate vsan 10
Forcing Fabric Binding Activation
If the database activation is rejected due to one or more conflicts listed in the previous section, you may
decide to proceed with the activation by using the force option.
To forcefully activate the fabric binding database, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fabric-binding activate vsan 3 force
switch(config)# no fabric-binding activate vsan 3 force
Saving Fabric Binding Configurations
When you save the fabric binding configuration, the config database is saved to the running
configuration.
You cannot disable fabric binding in a FICON-enabled VSAN.
Caution
•
OL-18084-01, Cisco MDS NX-OS Release 4.x
Use the fabric-binding database copy vsan command to copy from the active database to the
config database. If the configured database is empty, this command is not accepted.
switch# fabric-binding database copy vsan 1
Fabric Binding Configuration
Purpose
Enters configuration mode.
Activates the fabric binding database for
the specified VSAN.
Deactivates the fabric binding database for
the specified VSAN.
Purpose
Enters configuration mode.
Activates the fabric binding database
for the specified VSAN
forcefully—even if the configuration
is not acceptable.
Reverts to the previously configured
state or to the factory default (if no
state is configured).
Cisco MDS 9000 Family CLI Configuration Guide
40-5
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
