Activating A Manually Configured Ivr Topology - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Configuring IVR
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure a user-defined IVR topology database, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# ivr vsan-topology database
switch(config-ivr-topology-db)#
Step 3
switch(config-ivr-topology-db)# autonomous-fabric-id 1
switch 20:00:00:05:30:01:1b:b8 vsan-ranges 1-2,6
switch(config-ivr-topology-db)# autonomous-fabric-id 1
switch 20:00:00:05:30:01:1b:c2 vsan-ranges 1-3
switch(config-ivr-topology-db)# no autonomous-fabric-id
1 switch 20:00:00:05:30:01:1b:c2 vsan-ranges 1-2
Step 4
switch(config-ivr-topology-db)# end
switch#
View your configured IVR topology using the show ivr vsan-topology command. In the following
example output, VSAN 2 is the transit VSAN between VSANs 1, 5, and 6.
switch# show ivr vsan-topology
AFID
--------------------------------------------------------------
Total:
Current Status: Inter-VSAN topology is INACTIVE
If CFS is not enabled, you must repeat this configuration in all IVR-enabled switches. See the
Note
Merge Guidelines" section on page
Tip
Transit VSANs are deduced based on your configuration. The IVR feature does not have an explicit
transit-VSAN configuration.
Activating a Manually Configured IVR Topology
After manually configuring the IVR topology database, you must activate it.
Active IVR topologies cannot be deactivated. You can only switch to IVR topology automatic mode.
Caution
Cisco MDS 9000 Family CLI Configuration Guide
23-20
SWITCH WWN
1
20:00:00:05:30:01:1b:c2 *
1
20:02:00:44:22:00:4a:05
1
20:02:00:44:22:00:4a:07
3 entries in active and configured IVR VSAN-Topology
Active
Cfg. VSANS
no
yes
1-2
no
yes
1-2,6
no
yes
2-5
23-36.
Chapter 23
Configuring Inter-VSAN Routing
Purpose
Enters configuration mode.
Enters the VSAN topology database
configuration mode for the IVR
feature.
Configures VSANs 1, 2, and 6 to
participate in IVR for this switch.
Configures VSANs 1, 2 and 3 to
participate in IVR for this switch.
Removes VSANs 1 and 2 from IVR
for this switch.
Reverts to EXEC mode.
OL-18084-01, Cisco MDS NX-OS Release 4.x
"Database
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
