hit counter script

Configuring Fspf Link Cost; About Hello Time Intervals; Configuring Hello Time Intervals; About Dead Time Intervals - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs Also See for AP776A - Nexus Converged Network Switch 5020:
Table of Contents

Advertisement

Chapter 26
Configuring Fibre Channel Routing Services and Protocols
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring FSPF Link Cost

To configure FSPF link cost, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf cost 5 vsan 90

About Hello Time Intervals

You can set the FSPF Hello time interval to specify the interval between the periodic hello messages sent
to verify the health of the link. The integer value can range from 1 to 65,535 seconds.
This value must be the same in the ports at both ends of the ISL.
Note

Configuring Hello Time Intervals

To configure the FSPF Hello time interval, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf hello-interval 15 vsan 175
switch(config-if)#

About Dead Time Intervals

You can set the FSPF dead time interval to specify the maximum interval for which a hello message must
be received before the neighbor is considered lost and removed from the database. The integer value can
range from 1 to 65,535 seconds.
Note
This value must be the same in the ports at both ends of the ISL.
OL-18084-01, Cisco MDS NX-OS Release 4.x
FSPF Interface Configuration
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Configures the cost for the selected interface in
VSAN 90.
Purpose
Enters configuration mode.
Configures the specified interface, or if
already configured, enters configuration
mode for the specified interface.
Specifies the hello message interval (15
seconds) to verify the health of the link in
VSAN 175. The default is 20 seconds.
Cisco MDS 9000 Family CLI Configuration Guide
26-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents