Setting The Priority For The Virtual Router - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Chapter 44
Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 5
switch(config-if-vrrp-ipv6)# address
2001:0db8:800:200c::417a
switch(config-if-vrrp-ipv6)# no address
2001:0db8:800:200c::417a
Setting the Priority for the Virtual Router
The valid range to assign a virtual router priority is 1 to 254 with 1 being the lowest priority and 254
being the highest priority. The default value is 100 for switches with secondary IP addresses and 255 for
switches with the primary IP address.
To set the priority for a virtual router using IPv4, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface vsan 10
switch(config-if)#
Step 3
switch(config-if)# vrrp 250
switch(config-if-vrrp)#
Step 4
switch(config-if-vrrp)# priority 2
switch(config-if-vrrp)# no priority
To set the priority for a virtual router using IPv6, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface vsan 12
switch(config-if)#
Step 3
switch(config-if)# vrrp ipv6 200
switch(config-if-vrrp-ipv6)#
Step 4
switch(config-if-vrrp-ipv6)# priority 2
switch(config-if-vrrp-ipv6)# no priority
OL-18084-01, Cisco MDS NX-OS Release 4.x
Virtual Router Redundancy Protocol
Purpose
Assigns single primary link-local IPv6 address
or one of the multiple secondary IPv6
addresses.
If this IPv6 address is the same as the
Note
physical IPv6 address, this switch is
automatically the owner of this IPv6
address.
Removes the IPv6 address for the selected VR.
Purpose
Enters configuration mode.
Configures a VSAN interface (VSAN 10).
Creates a virtual router.
Configures the priority for the selected VRRP.
Note
Priority 255 cannot be preempted.
Reverts to the default value (100 for switch with
the secondary IPv4 addresses and 255 for
switches with the primary IPv4 address).
Purpose
Enters configuration mode.
Configures a VSAN interface (VSAN 12).
Creates a virtual router.
Configures the priority for the selected VRRP.
Note
Priority 255 cannot be preempted.
Reverts to the default value (100 for switch with
the secondary IPv6 addresses and 255 for
switches with the primary IPv6 address).
Cisco MDS 9000 Family CLI Configuration Guide
44-21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
