Table of Contents
Advertisement
Chapter 3
Installing the DPA 7630/7610
Installing the DPA 7630/7610
Installing the DPA 7630/7610 in a Rack
Warning
Attaching the Brackets
78-11069-03
Ethernet cable for connection to an Ethernet port
•
•
Telco cabling for connection to the Octel and PBX systems
You have the option of installing the DPA 7630/7610 in a 19-inch rack or setting
it on a shelf or other flat surface. Refer to these sections for detailed instructions:
Installing the DPA 7630/7610 in a Rack, page 3-5
•
Setting the DPA 7630/7610 on a Shelf or Table, page 3-7
•
The DPA 7630/7610 includes the brackets and screws required to install it in a
19-inch rack. Follow these instructions to install it safely and securely.
To prevent bodily injury when mounting or servicing this unit in a rack, you must
take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in
•
the rack.
When mounting this unit in a partially filled rack, load the rack from the
•
bottom to the top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
The chassis comes with brackets for use with a 19-inch rack. To install the chassis
in a rack, attach the brackets in one of the following ways:
•
With the front panel forward (see
With the rear panel forward (see
•
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
Installing the DPA 7630/7610
Figure
3-1)
Figure
3-2)
3-5
Advertisement
Chapters
Table of Contents
Troubleshooting
