Cisco Vg310 And Cisco Vg320 Voice Gateways Hardware Installation Guide - Cisco VG310 Hardware Installation Manual

Voice gateway

Hide thumbs Also See for VG310:

Installing manual (26 pages)

Table Of Contents

Table of Contents

Using the setup Command Facility

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Step 3

To continue with the configuration, enter yes.

The following message is displayed:

Would you like to enter basic management setup? [yes/no]:

Note

Step 4

Enter yes to continue.

The following message is displayed:

Configuring global parameters:

Enter host name [Router]:

Step 5

Enter a hostname for the voice gateway.

The following message is displayed:

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

entered, becomes encrypted in the configuration.

Enter enable secret:

Step 6

Enter an enable secret password. This password is encrypted and cannot be seen when viewing the

configuration.

The following message is displayed:

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password:

Step 7

Enter an enable password that is different from the enable secret password. This password is not encrypted

(and is less secure) and can be seen when viewing the configuration.

The following message is displayed:

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password:

Step 8

Enter the virtual terminal password and press Enter. The virtual terminal password prevents unauthenticated

access to the gateway through ports other than the console port. The following message is displayed:

Configure SNMP Network Management? [no]:

Step 9

Enter yes.

A summary of the available interfaces is displayed, as shown in the following example:

Current interface summary

Interface

GigabitEthernet0/0

GigabitEthernet0/1

Any interface listed with OK? value "NO" does not have a valid configuration

Step 10 Select one of the available interfaces to connect the voice gateway to the management network. In the following

example, gigabitethernet0/1 is selected:

Enter interface name used to connect to the

management network from the above interface summary: gigabitethernet0/1

Step 11 Respond to the following prompts as appropriate for your network:

Configuring interface GigabitEthernet0/1:

Configure IP on this interface? [yes]: yes