Tunnel Mode Ipv6Ip - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
53
1019
Parameters
•
router-name
—Specifies the router's domain name.
Default Configuration
The automatic tunnel router's default domain name is ISATAP.
Command Mode
Interface (Tunnel) Configuration mode
User Guidelines
This command determines the string that the host uses for automatic tunnel router
lookup in the IPv4 DNS procedure. By default, the string ISATAP is used for the
corresponding automatic tunnel types.
Only one string can represent the automatic tunnel router name per tunnel. Using
this command, therefore, overwrites the existing entry.
The empty string means that automatic lookup is not applied.
Example
The following example configures the global string ISATAP2 as the automatic
tunnel router domain name.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
53.5 tunnel mode ipv6ip
To configure a static IPv6 tunnel interface, use the tunnel mode ipv6ip command in
Interface (Tunnel) Configuration mode. To remove an IPv6 tunnel interface, use the
no form of this command.
Syntax
tunnel mode ipv6ip isatap
no tunnel mode ipv6ip
interface tunnel 1
tunnel isatap router
exit
OL-32830-01 Command Line Interface Reference Guide
IPv6 Tunnel Commands
ISATAP2
Advertisement
Table of Contents
