Tunnel Source - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
53
1021
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
53.6 tunnel source
To set the local (source) IPv4 address of a tunnel interface, use the tunnel source
command in Interface (Tunnel) Configuration mode. To delete the tunnel local
address, use the no form of the command.
Syntax
| ipv4-address
tunnel source {auto
no tunnel source
Parameters
•
auto—The system minimum IPv4 address is used as the local IPv4 address
(IPv4 address of the local tunnel endpoint).
•
ip4-address
—Specifies the IPv4 address to use as the local IPv4 address
(IPv4 address of the local tunnel endpoint).
•
interface-id
—Interface which the minimum IPv4 address is used as the
local IPv4 address (IPv4 address of the local tunnel endpoint).
Default
No source address is defined.
Command Mode
Interface (Tunnel) Configuration mode
User Guidelines
interface-id
If the auto or
tunnel local IPv4 address until it is defined. A new IPv4 interface is only chosen in
the following cases:
•
After reboot.
interface vlan 1
tunnel mode ipv6ip isatap
tunnel source 1.1.1.1
ipv6 address 3ffe:b00:c18:1::/64 eui-64
exit
interface-id
|
option is configured once time chosen IPv4 is used as the
OL-32830-01 Command Line Interface Reference Guide
IPv6 Tunnel Commands
}
Advertisement
Table of Contents
