Show Vlan Multicast-Tv - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
56
1087
Default Configuration
The port is not a member in any Multicast TV VLAN.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
When an existed Multicast-TV VLAN is assigned to a customer port, the multicast
messages received on a membership of the Multicast-TV VLAN are forwarded to
the customer port. All messages received on the customer port are not bridged
only into the Multicast-TV VLA.
To register IGMP reports arriving on the customer port by IGMP Snooping running
on the Multicast-TV VLAN, use the
Example
The following example enables gi 1 4 to receive Multicast transmissions from
VLANs 5, 6, 7.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
56.35 show vlan multicast-tv
Use the show vlan Multicast-tv EXEC mode command to display the source and
receiver ports of Multicast-TV VLAN. Source ports can transmit and receive traffic
to/from the VLAN, while receiver ports can only receive traffic from the VLAN.
Syntax
show vlan Multicast-tv vlan
Parameters
•
vlan-id
—Specifies the VLAN ID.
Default Configuration
N/A
Command Mode
User EXEC mode
Virtual Local Area Network (VLAN) Commands
ip igmp snooping map cpe vlan
interface gi14
switchport customer multicast-tv vlan add
vlan-id
OL-32830-01 Command Line Interface Reference Guide
command.
5-7
Advertisement
Table of Contents
