Spanning-Tree Mode - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
46
889
46.2 spanning-tree mode
Use the spanning-tree mode Global Configuration mode command to select
which Spanning Tree Protocol (STP) protocol to run. Use the no form of this
command to restore the default configuration.
Syntax
spanning-tree mode
|
}
mst
no spanning-tree mode
Parameters
•
stp—Specifies that STP is enabled.
•
rstp—Specifies that the Rapid STP is enabled.
•
mst—Specifies that the Multiple STP is enabled.
Default Configuration
The default is RSTP.
Command Mode
Global Configuration mode
User Guidelines
In RSTP mode, the device uses STP when the neighbor device uses STP.
In MSTP mode, the device uses RSTP when the neighbor device uses RSTP, and
uses STP when the neighbor device uses STP.
Example
The following example enables MSTP.
switchxxxxxx(config)#
{stp|
rstp
spanning-tree mode mst
OL-32830-01 Command Line Interface Reference Guide
Spanning-Tree Commands
Advertisement
Table of Contents
