Cisco 300 Series Cli Manual page 213

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Network Management Protocol (SNMP) Commands

78-21075-01 Command Line Interface Reference Guide

community-string—Password-like community string sent with the

notification operation. (Range: 1–20 characters). For v1 and v2, any

community string can be entered here. For v3, the community string must

match the user name defined in

Authentication options are available for SNMP v3 only. The following options

are available:

noauth—Specifies no authentication of a packet.

auth—Specifies authentication of a packet without encryption.

priv—Specifies authentication of a packet with encryption.

—UDP port of the host to use. The default is 162. (Range:

filter is defined using

imposed on the user). (Range: Up to 30 characters)

acknowledgment before resending informs. The default is 15 seconds.

(Range: 1–300)

—(For informs only) Maximum number of times to resend an

inform request, when a response is not received for a generated message.

The default is 3. (Range: 0–255)

Default Configuration

Version: SNMP V1

Type of notification: Traps

udp-port: 162

If informs are specified, the default for retries: 3

Command Mode

Global Configuration mode

User Guidelines

The logical key of the command is the list - ip-address/hostname, traps/informs,

snmp-server user

—Filter for this host. If unspecified, nothing is filtered. The

snmp-server filter

—(For informs only) Number of seconds to wait for an

(no specific order of commands is