Spanning-Tree Link-Type - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Spanning-Tree Commands

78-21075-01 Command Line Interface Reference Guide

Default Configuration

PortFast mode is disabled.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

The following example enables the PortFast mode on gi15.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

31.11 spanning-tree link-type

Use the spanning-tree link-type Interface Configuration (Ethernet, port-channel)

mode command to override the default link-type setting determined by the port

duplex mode, and enable RSTP transitions to the Forwarding state. Use the no

form of this command to restore the default configuration.

spanning-tree link-type

no spanning-tree spanning-tree link-type

point-to-point—Specifies that the port link type is point-to-point.

shared—Specifies that the port link type is shared.

Default Configuration

The device derives the port link type from the duplex mode. A full-duplex port is

considered a point-to-point link and a half-duplex port is considered a shared link.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

interface gi15

spanning-tree portfast

{point-to-point | shared}