Ipv6 Dhcp Client Information Refresh Minimum - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
52
User Guidelines
This command specifies the information refresh time. If the server does not send
an information refresh time option, the value configured by the command is used.
Use the infinite keyword to delete refresh, if the DHCP server does not send an
information refresh time option.
Example
The following example configures an upper limit of 2 days:
interface vlan 100
ipv6 dhcp client stateless
ipv6 dhcp client information refresh 172800
exit
52.4
ipv6 dhcp client information refresh minimum
Use the ipv6 dhcp client information refresh minimum command in Interface
Configuration mode to configure the minimum acceptable refresh time on the
specified interface.
Use the no form of this command to remove the configured refresh time.
Syntax
ipv6 dhcp client information refresh minimum
no ipv6 dhcp client information refresh minimum
Parameters
•
seconds—The refresh time, in seconds. The minimum value that can be
used is 600 seconds. The maximum value that can be used is 4,294,967,294
seconds (0xFFFFFFFE).
•
infinite—Infinite refresh time.
Default Configuration
The default is 86,400 seconds (24 hours).
seconds |
infinite
Advertisement
Table of Contents
