Show Cdp Traffic - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
36
598
CDP is enabled
Ethernet
1 is up,
gi
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4:
1.2.2.2 IPv6:
Port_ID TLV: gis1
Capabilities: S, I
Version TLV: 1 and 2
Platform TLV: VSD Ardd
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN_ID TLV: Appliance-ID is 1; VLAN-ID is 100
COS for Untrusted Ports TLV: 1
sysName: a-switch
Power Available TLV: Request-ID is 1 Power management-ID is 1;
Interface TLV: gi2
CDP is disabled on
gi
Interface TLV: gi3
CDP is enabled on
3
gi
Ethernet
3 is down
gi
36.21 show cdp traffic
The show cdp traffic Privileged EXEC mode command displays the CDP counters,
including the number of packets sent and received and checksum errors.
Syntax
show cdp traffic [global |
Parameters
•
global—Display only the global counters
Available-Power is 10;
Management-Power-Level is 0xFFFFFFFF
2
interface-id
]
78-21075-01 Command Line Interface Reference Guide
CDP Commands
Advertisement
Table of Contents
