Spanning-Tree Forward-Time - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
31
452
no spanning-tree mode
Parameters
•
stp—Specifies that STP is enabled.
•
rstp—Specifies that the Rapid STP is enabled.
•
mst—Specifies that the Multiple STP is enabled.
Default Configuration
The default is RSTP.
Command Mode
Global Configuration mode
User Guidelines
In RSTP mode, the device uses STP when the neighbor device uses STP.
In MSTP mode, the device uses RSTP when the neighbor device uses RSTP, and
uses STP when the neighbor device uses STP.
Example
The following example enables MSTP.
switchxxxxxx(config)#
31.3
spanning-tree forward-time
Use the spanning-tree forward-time Global Configuration mode command to
configure the spanning-tree bridge forward time, which is the amount of time a
port remains in the listening and learning states before entering the forwarding
state. Use the no form of this command to restore the default configuration.
Syntax
spanning-tree forward-time
no spanning-tree forward-time
spanning-tree mode mstp
seconds
78-21075-01 Command Line Interface Reference Guide
Spanning-Tree Commands
Advertisement
Table of Contents
