Priority-Queue Out Num-Of-Queues - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

The following assigns WRR values to the queues.

switchxxxxxx(config)#

49.19 priority-queue out num-of-queues

An expedite queue is a strict priority queue, which is serviced until empty before

the other lower priority queues are serviced.

Use the priority-queue out num-of-queues Global Configuration mode command

to configure the number of expedite queues. Use the no form of this command to

restore the default configuration.

priority-queue out num-of-queues

no priority-queue out num-of-queues

number-of-queues—Specifies the number of expedite (strict priority)

queues. Expedite queues are assigned to the queues with the higher

indexes. (Range: 0–4).

There must be either 0 wrr queues or more than one.

If number-of-queues = 0, all queues are assured forwarding (according to

wrr weights) If the number-of-queues = 4, all queues are expedited (strict

priority queues).

Default Configuration

All queues are expedite queues.

Command Mode

Global Configuration mode

User Guidelines

the weighted round robin (WRR) weight ratios are affected by the number of

expedited queues, because there are fewer queues participating in WRR. This

wrr-queue bandwidth

number-of-queues

78-21075-01 Command Line Interface Reference Guide

Quality of Service (QoS) Commands