hit counter script

Cisco Catalyst 2950 Command Reference Manual page 369

Hide thumbs Also See for Catalyst 2950:
Table of Contents

Advertisement

Chapter 2
Catalyst 2950 and 2955 Cisco IOS Commands
Table 2-22
Field
Port
Send FlowControl
Admin
Oper
Receive FlowControl
Admin
Oper
RxPause
TxPause
On
Off
Desired
Unsupp.
This is an example of output from the show interfaces switchport command for a single interface.
Table 2-23
Switch# show interfaces gigabitethernet0/1 switchport
Name: Gi0/1
Switchport:Enabled
Administrative Mode:dynamic desirable
Operational Mode:static access
Administrative Trunking Encapsulation:negotiate
Negotiation of Trunking:On
Access Mode VLAN:1 (default)
Trunking Native Mode VLAN:1 (default)
Voice VLAN:none
Administrative private-vlan host-association:none
Administrative private-vlan mapping:none
Operational private-vlan:none
Trunking VLANs Enabled:ALL
Pruning VLANs Enabled:2-1001
Capture Mode: Disabled
Capture VLANs Allowed:ALL
Protected:true
Unknown unicast blocked:disabled
Unknown multicast blocked:disabled
Voice VLAN:none (Inactive)
Appliance trust:none
0L-10102-01
show interfaces flowcontrol Field Descriptions
describes the fields in the output.
Description
Displays the port name.
Displays the administrative (configured) setting for the flow
control send mode.
Displays the operational (running) setting for the flow control
send mode.
Displays the administrative (configured) setting for the flow
control receive mode.
Displays the operational (running) setting for the flow control
receive mode.
Displays the number of pause frames received.
Displays the number of pause frames sent.
Flow control is enabled.
Flow control is disabled.
Flow control is enabled if the other end supports it.
Flow control is not supported.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show interfaces
2-341

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 2955

Table of Contents