Cisco Catalyst 2950 Command Reference Manual page 519

Hide thumbs Also See for Catalyst 2950:

Table of Contents

Catalyst 2950 and 2955 Cisco IOS Commands

This example shows how to assign a port already in access mode to VLAN 2 (instead of the default

Switch(config-if)# switchport access vlan 2

You can verify your settings by entering the show interfaces interface-id switchport privileged EXEC

command and examining information in the Administrative Mode and Operational Mode rows.

Related Commands

show interfaces

switchport mode

The software implements the VLAN Query Protocol (VQP) client, which can query a VMPS such

as a Catalyst 6000 series switch. The VMPS server must be configured before a port is configured

Use dynamic-access ports only to connect end stations. Connecting them to switches or routers that

use bridging protocols can cause a loss of connectivity.

Configure the network so that Spanning Tree Protocol (STP) does not put the dynamic-access port

in an STP blocking state. The Port Fast feature is automatically enabled on dynamic-access ports.

Dynamic-access ports can only be in one VLAN and do not use VLAN tagging.

Dynamic-access ports cannot be configured as:

Members of an EtherChannel port group (dynamic-access ports cannot be grouped with any

other port, including other dynamic ports).

Source or destination ports in a static address entry.

Monitor ports.

Displays the administrative and operational status of a switching

(nonrouting) port, including port blocking and port protection settings.

Configures the VLAN membership mode of a port.

Catalyst 2950 and Catalyst 2955 Switch Command Reference

switchport access

Catalyst 2955