Global Configuration Mode; Interface Configuration Mode - Cisco Catalyst 2950 Command Reference Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Software configuration manual (674 pages) ,
- Command reference manual (408 pages)
Table of Contents
Advertisement
CLI Command Modes
Global Configuration Mode
Global configuration commands apply to features that affect the device as a whole. Use the configure
privileged EXEC command to enter global configuration mode. The default is to enter commands from
the management console.
When you enter the configure command, a message prompts you for the source of the configuration
commands:
Switch# configure
Configuring from terminal, memory, or network [terminal]?
You can specify either the terminal or NVRAM as the source of configuration commands.
This example shows you how to access global configuration mode:
Switch# configure terminal
Enter configuration commands, one per line.
The supported commands can vary depending on the version of software in use. To view a
comprehensive list of commands, enter a question mark (?) at the prompt.
Switch(config)# ?
To exit global configuration command mode and to return to privileged EXEC mode, enter the end or
exit command, or press Ctrl-Z.
Interface Configuration Mode
Interface configuration commands modify the operation of the interface. Interface configuration
commands always follow a global configuration command, which defines the interface type.
Use the interface type_number.subif command to access interface configuration mode. The new prompt
shows interface configuration mode.
Switch(config-if)#
The supported commands can vary depending on the version of software in use. To view a
comprehensive list of commands, enter a question mark (?) at the prompt.
Switch(config-if)# ?
To exit interface configuration mode and to return to global configuration mode, enter the exit command.
To exit interface configuration mode and to return to privileged EXEC mode, enter the end command,
or press Ctrl-Z.
config-vlan Mode
Use this mode to configure normal-range VLANs (VLAN IDs 1 to 1005) or, when VTP mode is
transparent, to configure extended-range VLANs (VLAN IDs 1006 to 4094). When VTP mode is
transparent, the VLAN and VTP configuration is saved in the running configuration file, and you can
save it to the switch startup configuration file by using the copy running-config startup-config
privileged EXEC command. The configurations of VLAN IDs 1 to 1005 are saved in the VLAN database
if VTP is in transparent or server mode. The extended-range VLAN configurations are not saved in the
VLAN database.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
1-4
Chapter 1
Using the Command-Line Interface
End with CNTL/Z.
OL-10102-01
Advertisement
Table of Contents
