Mvr Vlan Group - Cisco Catalyst 2950 Command Reference Manual

Hide thumbs Also See for Catalyst 2950:

Table of Contents

Catalyst 2950 and 2955 Cisco IOS Commands

mvr vlan group

Use the mvr vlan group interface configuration command to statically configure a receiver port as a

member of a multicast VLAN registration (MVR) group in a particular VLAN. Use the no form of this

command to remove the port from the MVR group.

Syntax Description

vlan vlan-id

group ip-address

A port is configured as neither receiver nor source.

Command Modes

Interface configuration

Command History

Usage Guidelines

The receiver port belongs to a multicast VLAN.

The group address is configured as a MVR group address.

This example shows how to configure a static MVR group entry on port 1 in VLAN 10:

Switch(config)# interface fastethernet0/1

Switch(config-if)# mvr vlan 10 group 225.1.1.1

This example shows how to remove an entry on port 3 in VLAN 10:

Switch(config)# interface fastethernet0/3

Switch(config-if)# no mvr 10 group 255.1.1.2

You can verify your settings by entering the show mvr privileged EXEC command.

mvr vlan vlan-id group ip-address

no mvr vlan vlan-id group ip-address

Specify the VLAN ID to which the receiver port belongs. The range is 1 to

Specify the MVR group address for which the interface is statically

configured to be a member.

Modification

This command was introduced.

Catalyst 2950 and Catalyst 2955 Switch Command Reference

mvr vlan group

Catalyst 2955