Cisco Catalyst 2950 Command Reference Manual page 139
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Software configuration manual (674 pages) ,
- Command reference manual (408 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 2950 and 2955 Cisco IOS Commands
On Catalyst 2950 Long-Reach Ethernet (LRE) switches, use the duplex command to configure both the
MAC and LRE chipsets.
A 10/100/1000 LRE switch port autonegotiates with the device at the other end of the link for the duplex
setting and then forces the duplex setting to the negotiated value. A fiber-optic connection (SFP) also
autonegotiates with the device at the other end of the link but only accepts a connection at full duplex.
The duplex setting for a SFP Gigabit Ethernet port has a close relationship to the setting for speed.
Fiber-optic connections are always forced to 1000 Mbps and full-duplex mode. Copper connections can
run at either full- or half-duplex mode for 10 or 100 Mbps but are can only run in full-duplex mode at
1000 Mbps. When you manually set the speed and duplex settings, autonegotiation is disabled, and
speed and duplex settings can cause a mismatch.
For guidelines on setting the switch speed and duplex parameters, see the software configuration guide
Note
for this release.
Examples
This example shows how to set a port to half duplex:
Switch(config)# interface fastethernet0/1
Switch(config-if)# duplex half
This example shows how to set a port to full duplex:
Switch(config)# interface fastethernet0/1
Switch(config-if)# duplex full
You can verify your settings by entering the show interfaces transceiver properties or
show running-config privileged EXEC command.
Related Commands
Command
cpe duplex
local duplex
show running-config
speed
OL-10102-01
Description
Sets the duplex setting for customer premises equipment (CPE) Ethernet
ports.
Sets the duplex mode on an LRE port.
Displays the configuration information running on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference for Release 12.1 > Cisco IOS File Management Commands >
Configuration File Commands.
Sets the port speed.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
duplex
2-109
Advertisement
Table of Contents
