Table of Contents
Advertisement
addcid
addcid
To add an AAL2 channel identifier (CID) on a VISM card, use the addcid command in the AAL2
trunking operating mode.
Syntax Description
endpt-num
lcn
cid-num
Cisco VISM Installation and Configuration Guide
5-8
addcid endpt-num lcn cid-num codec-type profile-type profile-num |vad-enable vad-init-timer
ecan-enable type-3-red cas-trans dtmf-trans idle-code-sup pkt-period|
The endpoint number which is to be related to the LCN/CID pair being added. It
can be a value from one of the following ranges:
•
For template number 1:
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
For template number 2:
•
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•
For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
For VISM-PR E1, from 1 to 248
–
For template number 4:
•
For VISM-PR, from 1 to 144
–
The logical channel number (LCN) of the LCN/CID pair in the range from 131 to
510.
The channel identification number of the LCN/CID pair in the range from 8 to 255.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
