Table of Contents
Advertisement
cnfaal2transparams
cnfaal2transparams
To configure the transportation of DTMF and CAS bits to another endpoint and enable or disable type 3
packet triple redundancy feature, use the cnfaal2transparams command in the switched AAL2 PVC
operating mode.
Syntax Description
dtmf-trans
cas-bits-trans
type-3-red
Command Modes
Switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures when using this command.
Examples
The following example shows that DTMF tone transportation, CAS bits transportation, and triple
redundancy protection are enabled:
cnfaal2transparams 1 1 1
Related Commands
There are no related commands.
Cisco VISM Installation and Configuration Guide
5-68
cnfaal2transparams dtmf-trans cas-bits-trans type-3-red
Enables or disables DTMF tone transport as AAL2 type 3 packets. It can be one of
the following values:
1 = On. DTMF relay using RFC 2833.
2 = Off. DTMF pass through.
The dtmf-trans argument value must be set to 1 (on) if you are using codecs
Note
other than G.711 and G.726.
Enables or disables CAS bits transportation. It can be one of the following values:
1 = On
•
2 = Off
•
Enables or disables triple redundancy protection for type 3 packets. It can be one
of the following values:
•
1 = On
•
2 = Off
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
