Table of Contents
Advertisement
addcid
|vad-init-timer|
|ecan-enable|
|type-3-red|
|cas-trans|
|dtmf-trans|
|idle-code-sup|
|pkt-period|
Command Modes
AAL2 trunking
Usage Guidelines
This command establishes a relationship between an endpoint and an LCN/CID pair. The endpoint is
bound to a DS0 and the CID binds a DS0 to a logical channel—ensuring an endpoint-to-endpoint trunk.
The following conditions must be met before you use this command:
•
•
Cisco VISM Installation and Configuration Guide
5-10
(Optional) The VAD initial (holdover) timer in the range from 250 to 65535 ms.
Default = 250.
(Optional) Enables or disables echo cancellation (ECAN). It can be one of the
following values:
•
1 = On
•
2 = Off
(Optional) Enables or disables triple redundancy protection for type 3 packets. It
can be one of the following values:
1 = On
•
2 = Off
•
If you select 1 for this argument value, either the cas-trans or dtmf-trans
Note
argument value must be set to 1 (on).
(Optional) Enables or disables channel associated signaling (CAS) transport as
AAL2 type3 packets. It can be one of the following values:
1 = On (Default)
2 = Off
This parameter does not affect any inbound signaling.
(Optional) Enables or disables DTMF tone transport as AAL2 type 3 packets. It can
be one of the following values:
1 = On (Default)
2 = Off
The dtmf-trans argument value must be set to 1 (on) when the codec-type
Note
is configured for codecs other than G.711 and G.726.
(Optional) Enables or disables idle code suppression for the CID. It can be one of
the following values:
1 = On
2 = Off
(Optional) Packetization period (defined in milliseconds). Applies only to G.729a
compression. It can be the following value:
10
•
Note
The pkt-period argument applies only to G.729a compression (codec-type
argument value = 4). If you have selected any other compression value,
ignore this argument.
A previously added endpoint must exist.
PVC must be of bearer type and provisioned using the addcon command.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
