Table of Contents
Advertisement
delendpt
delendpt
To delete a specified endpoint on a VISM card line, use the delendpt command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
An endpoint cannot be deleted if CIDs are present.
This command results in a graceful transition to out of service and an RSIP to be sent to each associated
call agent indicating the endpoint out-of-service state.
Examples
The following example shows that endpoint number 120 is deleted:
delendpt 120
Related Commands
Command
addendpt
dspendpt
dspendpts
Cisco VISM Installation and Configuration Guide
5-252
delendpt endpt-num
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
For template number 3:
•
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 4:
–
For VISM-PR, from 1 to 144
Description
Adds an endpoint on a VISM card.
Displays data about a specified endpoint on a VISM card.
Displays information about all endpoints on a VISM card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
