Power On The Switch; Running Post - Cisco Catalyst 2955 Hardware Installation Manual
Cisco systems switch installation guide
Hide thumbs
Also See for Catalyst 2955:
- Installation notes (12 pages) ,
- Configuration manual (710 pages) ,
- Command reference manual (686 pages)
Table of Contents
Advertisement
Chapter 3
Installation
Power On the Switch
Caution
Note
Running POST
Note
78-14944-03
Remove the protective liner before applying power to the switch.
Failure to remove the protective liner could result in thermal damage to the
switch.
To apply power to a switch that is directly connected to a DC power source, locate
the circuit breaker on the panel board that services the DC circuit, and switch the
circuit breaker to the ON position.
For instructions on how to apply power to a switch that is connected to a power
converter, see the
"Applying Power to the Power Converter" section on page
After the power is connected, the switch automatically begins POST, a series of
tests that verifies that the switch functions properly.
The uplink port status LEDs provide system and status information during POST.
On the Catalyst 2955C-12 and 2955S-12, the uplink ports are labeled 13 and 14.
On the Catalyst 2955T-12, the uplink ports are labeled 1 and 2.
When the Catalyst 2955C-12 and 2955S-12 begin POST:
Uplink port 13 LED is amber.
•
Uplink port 14 LED blinks green.
•
When the Catalyst 2955T-12 begins POST:
Uplink port 1 LED is amber.
•
•
Uplink port 2 LED blinks green.
Verifying Switch Operation
Catalyst 2955 Hardware Installation Guide
3-46.
3-27
Hide quick links:
Advertisement
Table of Contents
