Enabling Bpdu Filtering - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Configuring Optional Spanning-Tree Features
To disable BPDU guard, use the no spanning-tree portfast bpduguard default global configuration
command.
You can override the setting of the no spanning-tree portfast bpduguard default global configuration
command by using the spanning-tree bpduguard enable interface configuration command.
Enabling BPDU Filtering
When you globally enable BPDU filtering on Port Fast-enabled interfaces, it prevents interfaces that are
in a Port Fast-operational state from sending or receiving BPDUs. The interfaces still send a few BPDUs
at link-up before the switch begins to filter outbound BPDUs. You should globally enable BPDU
filtering on a switch so that hosts connected to these interfaces do not receive BPDUs. If a BPDU is
received on a Port Fast-enabled interface, the interface loses its Port Fast-operational status, and BPDU
filtering is disabled.
Configure Port Fast only on interfaces that connect to end stations; otherwise, an accidental topology
Caution
loop could cause a data packet loop and disrupt switch and network operation.
You can also use the spanning-tree bpdufilter enable interface configuration command to enable
BPDU filtering on any interface without also enabling the Port Fast feature. This command prevents the
interface from sending or receiving BPDUs.
Caution
Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in
spanning-tree loops.
You can enable the BPDU filtering feature if your switch is running PVST+, rapid PVST+, or MSTP.
Beginning in privileged EXEC mode, follow these steps to globally enable the BPDU filtering feature.
This procedure is optional.
Command
Step 1
configure terminal
Step 2
spanning-tree portfast bpdufilter default
Step 3
interface interface-id
Step 4
spanning-tree portfast
Step 5
end
Step 6
show running-config
Step 7
copy running-config startup-config
To disable BPDU filtering, use the no spanning-tree portfast bpdufilter default global configuration
command.
You can override the setting of the no spanning-tree portfast bpdufilter default global configuration
command by using the spanning-tree bpdufilter enable interface configuration command.
Cisco IE 3000 Switch Software Configuration Guide
20-12
Chapter 20
Purpose
Enter global configuration mode.
Globally enable BPDU filtering.
By default, BPDU filtering is disabled.
Specify the interface connected to an end station, and enter
interface configuration mode.
Enable the Port Fast feature.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring Optional Spanning-Tree Features
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
