Table of Contents
Advertisement
Chapter
Table 8-6
Error Number
6155
6157
6165
6166
6167
6170
6171
6172
6201
6202
6221
6222
6223
6224
6225
6226
6227
6228
6229
6230
6231
6241
6242
6224
6225
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
AUSM Log Codes (continued)
Display Log String
Rate Control feature
changed to
AUSM got time from ASC
ASC request to go to default AUSM received message from ASC to use default
AUSM using the default
Config.
ASC sent slot number to SM AUSM received slot information from ASC. Displays
Added Egress Queue
Deleted Egress Queue
Modified Egress Queue
CSE decision not read
CSE Enable Failed
Invalid Connection Request Connection request from CDMA is neither for VCC
PLPP write FIFO full
CDMA Exception
Duplicate Connection Open Found a duplicate entry while trying add to address
Unknown connection close
IBS queue full
ABR queue full
No free ingress data buffers Could not find free buffer from ingress free data pool.
No free ingress ILMI buffers Could not find free buffer from ingress ILMI free
No free ingress OAM
buffers
cellDmaEnablePort Failed
CDMA Ping Error
Error from CDMA
Cannot Load CDMA
firmware
Cell DMA Enable Failed
Detail Description
Rate control feature is changed. Whether it is turned
on or off is displayed.
AUSM received date and time from the ASC.
values for configuration.
AUSM card is using default values for configuration
parameters.
the slot number after validation.
A new egress queue has been added. Egress queue
number is displayed.
An egress queue is deleted, queue number is
displayed.
Egress queue is modified, queue number is displayed.
Cell DMA has not read the service decision for Egress
queue servicing.
Cell service engine enable failed.
or VPC connection.
Failed while trying to write to PLPP FIFO.
A CDMA exception has occurred.
translation table.
Did not find entry in address translation table for
closing.
Found IBS queue full while trying to enqueue cell.
Found ABR queue full while trying to enqueue cell.
pool.
Could not find free buffer from ingress OAM-ree pool
Failed trying to enable CDMA for a port. Port number
is displayed.
Cell DMA module is not responding.
Cell DMA reports error. Addtional information on the
specific instance is displayed.
Unable able to load CDMA firmware.
Failed to enabled cell DMA.
Cisco MGX 8220 Installation and Configuration
Log Codes
8-19
Advertisement
Table of Contents
Troubleshooting
