Table of Contents
Advertisement
Chapter
Table 8-3
Error Number
1310
1311
1312
1313
1314
1315
1316
1400
1401
1402
1403
1404
1405
1406
1407
1408
1409
1410
1411
1412
1500
1501
1502
1503
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
ASC Log Codes (continued)
Display Log String
sendto - call err, or did not
xmt all data
executing STANDBY
card code, wrong thread
local IP address not
programmed
receive size error
tx data size error
error number =
general error
msg send error
LCN out of range
xmt buffer not available
xmt failure
cell type error
msg rcv error
rcv failure
VC table full
VC entry not found
VC state error
unknown command
AUM LCN list ptr is 0
AUM req send AIS again BNM (AUM) has sent the command to send the AIS
Receive Queue Error
Transmit Queue Error
Bad Source ID
Bad Destination ID
Detail Description
Failed to transmit the IP data packet. System call error
or failed to transmit all the data.
Executing wrong thread. STANDBY card code has been
executed.
No interface has been configured with a local IP address.
Failed to receive the SNMP PDU. System call error.
Invalid packet data length. Packet cannot be sent.
General NMIM error occurred, for example, queue send
failure, bad source address, and authentication failure.
Not used.
Failed to send a message to another task through a
message queue.
Not used.
Failed to send an OAM cell. Transmit buffers not
available.
Error occurred while transmitting the OAM cell. SAR
transmit queue is full.
Invalid OAM cell type.
Error occurred while receiving a message from another
task through a message queue.
Error occurred while receiving an OAM cell from the
SAR module.
The OAM VC table if full. Cannot accept one more
entry.
Not used.
OAM VC table is not in the expected state to execute the
particular command from another task.
Unknown OAM command received from another task.
OAM cell missing the list of LCNs.
cells for the same VC, again.
LMI task failed to receive a message sent by another task
through a message queue.
LMI task failed to transmit a message to another task
through a message queue.
Message received from an unknown source through a
message queue. Bad source ID.
Message not meant for LMI task has been received
through a message queue. Bad destination ID.
Cisco MGX 8220 Installation and Configuration
Log Codes
8-9
Advertisement
Table of Contents
Troubleshooting
