Table of Contents
Advertisement
Chapter
Save TFTP Command Format
This mechanism allows copying a FRSM configuration file (saved on the PCMCIA hard drive) to a
network file system using a TFTP file command.
TFTP file name format
TFTP client operation
For example, the command get AXIS_SM_1_5.PRI.serviceuser saves the configuration file for the
service module in slot 5 by reading the FRSM 5 configuration stored in the PCMICIA hard drive.
Restore TFTP Command Format
This mechanism allows the user to copy a FRSM configuration file from a network file system to the
corresponding FRSM configuration file on ASC PCMCIA hard drive.
FTP file name format
TFTP client operation
This will restore the FRSM 5 configuration.
For example, put AXIS_SM_1_5.PRI.serviceuser places the configuration file onto the service
module in slot 5.
Note
The uploaded file is a binary file.
You will lose some configuration changes if they are made after the back-up was performed.
Note
The configuration file contains feature information. If they do not match the feature information on
the FRSM, the FRSM goes into mismatch state.
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
AXIS_SM_1_ slot number.PRI. service user password
<UNIX prompt> tftp AXIS ip address
> bin
> get AXIS_SM_1_5.PRI.serviceuser
AXIS_SM_1_ slot number .PRI. service user password
<UNIX prompt> tftp AXIS address
> bin
> put network file name AXIS_SM_1_5.PRI.serviceuser
Cisco MGX 8220 Installation and Configuration
TFTP User Interface
3-19
Advertisement
Table of Contents
Troubleshooting
