Table of Contents
Advertisement
Log Codes
Table 8-3
Error Number
1231
1232
1233
1234
1235
1236
1237
1280
1281
1282
1283
1301
1302
1303
1304
1305
1306
1307
1308
1309
Cisco MGX 8220 Installation and Configuration
8-8
ASC Log Codes (continued)
Display Log String
BERT informational
Unable to spawn
ascSrmDetectedTask
Error in srm common task
message
SRM peer mismatch
detected
SRM config. mismatch
detected
SRM card failed
switchcc reason
Q not present
atmRx task spawn fail
error in recv msg Q
PDU received bigger than
2032
snmp pdu auth parse err
snmp varbind parse err
mgmt buffer shortage
SR agent gen err
destination of PDU
unknown
err making varbind for
trap PDU
unable to open
SNMP-161 port
unable to bind SNMP-161
port
message recv call
generated error
Detail Description
Error occurred in a BERT-related module. Additional
information describing the specific instance of error is
displayed.
Error occurred while spawning the SRM detected task.
Invalid message received from the SRM task. Additional
information describing the specific instance of the error
is displayed.
Type mismatch between the active and the redundant
service module card types.
Type mismatch between the active and the redundant
card configurations.
SRM card failure detected. Additional information
about the card is also displayed.
Standby ASC card has been allowed mastership, because
the active ASC does not have an SRM card. Additional
information describing the specific instance is
displayed.
Error occurred while accessing the ATM message queue.
Failed to get the number of messages in the queue.
Failed to spawn the ATM receiver task.
Error occurred while receiving message from the ATM
message queue.
The length of the PDU received through the ATM
receive queue exceeds the maximum value.
Authentication in SNMP PDU failed while parsing.
Failed trying to parse varbinds in SNMP PDU.
Not used.
SNMP PDU to be forwarded to the agent failed
authentication.
Not used.
Not used.
Error occurred while opening the SNMP UDP port 161.
Error occurred while binding the SNMP UDP port 161.
General NMIM error occurred like malloc failure,
message queue send/receive failure, and so on.
Additional information describing the specific instance
is displayed.
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter
Advertisement
Table of Contents
Troubleshooting
