Cisco Small Business RV315W Administration Manual page 45
Broadband wireless vpn router
Hide thumbs
Also See for Small Business RV315W:
- Datasheet (9 pages) ,
- Quick start manual (13 pages) ,
- Administration manual (102 pages)
Table of Contents
Advertisement
Port Management
Configuring WAN
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco RV315W Broadband Wireless VPN Router Administration Guide
•
Number of Pings: Enter the number of pings. The default is 1.
•
Recover the connection after x connection queries: Enter the number of
successful ping detections to recover the connection. The WAN connection
with the higher priority will be recovered.
In the Failover Detection area, specify the IP address used to detect the WAN
failure. By default, RV315W pings the IP address of default WAN gateway with the
higher priority. If the default WAN gateway can be detected, the network
connection is active. You can also ping a specific remote host to detect the WAN
failure.
•
Gateway: Pings the IP address of default WAN gateway.
•
User-defined: Pings a specific remote host. If you choose this option, enter
the IP address of the specific remote host to ping.
In the WAN Interfaces area, specify the priorities for the WAN interfaces, including
the 3G USB port:
•
Interface: Name of the WAN interface.
•
Status: Connection status of the WAN interface.
•
Priority: Choose the priority of the WAN interface from the drop-down
menu.
In the WAN Interface Details area, view the following information of the WAN
interfaces:
•
Interface: Name of the WAN interface.
•
IP Address: IP address of the WAN interface.
•
Subnet Mask: Subnet mask of the WAN interface.
•
Gateway: Default gateway IP address of the WAN interface.
In the Load Balancing area, click Enable to enable Load Balancing to distribute the
bandwidth to two WAN ports by the weighted percentages, or click Disable to
disable this feature.
In the Load Balancing Settings area, specify the weighted percentage for each
WAN interface, such as 50% bandwidth for WAN0, 50% bandwidth for WAN1, and
0% for USB_3G, which indicates that 50% bandwidth is distributed to WAN0 and
50% bandwidth is distributed to WAN1. The value of zero (0) indicates that Load
Balancing is disabled on the 3G WAN interface.
4
42
Advertisement
Table of Contents
