Recovering The Server Firmware - IBM x3250 M3 Problem Determination And Service Manual
Hide thumbs
Also See for x3250 M3:
- Installation and user manual (102 pages) ,
- Product manual (37 pages) ,
- Manual (32 pages)
Table of Contents
Advertisement
Recovering the server firmware
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code.
If the server firmware has become corrupted, such as from a power failure during
an update, you can recover the server firmware in one of two ways:
v In-band method: Recover server firmware, using either the boot block jumper
v Out-of-band method: Use the IMM Web Interface to update the firmware, using
Note: You can obtain a server update package from one of the following sources:
v Download the server firmware update from the World Wide Web.
v Contact your IBM service representative.
To download the server firmware update package from the World Wide Web,
complete the following steps.
Note: Changes are made periodically to the IBM website. The actual procedure
might vary slightly from what is described in this document.
1. Go to http://www.ibm.com/systems/support/.
2. Under Product support, click System x.
3. Under Popular links, click Software and device drivers.
4. Click System x3250 M3 to display the matrix of downloadable files for the
5. Download the latest server firmware update.
The flash memory of the server consists of a primary bank and a backup bank. It is
essential that you maintain the backup bank with a bootable firmware image. If the
primary bank becomes corrupted, you can either manually boot the backup bank
with the boot block jumper, or in the case of image corruption, this will occur
automatically with the Automated Boot Recovery function.
In-band manual recovery method
To recover the server firmware and restore the server operation to the primary
bank, complete the following steps:
(Automated Boot Recovery) and a server Firmware Update Package Service
Pack.
the latest server firmware update package.
server.
1. Turn off the server, and disconnect all power cords and external cables.
2. Remove the server cover. See "Removing the cover" on page 130 for more
information.
3. Locate the boot block jumper (JP6) on the system board.
113
Chapter 3. Diagnostics
Hide quick links:
Advertisement
Table of Contents
