Hard Disk Drive - IBM x3250 M3 Problem Determination And Service Manual
Hide thumbs
Also See for x3250 M3:
- Installation and user manual (102 pages) ,
- Product manual (37 pages) ,
- Manual (32 pages)
Table of Contents
Advertisement
10. Install the cover (see "Installing the cover" on page 130).
11. Slide the server into the rack.
12. Reconnect the power cord and any cables that you removed.
13. Turn on the peripheral devices and the server.
Hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this section.
Attention:
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
Note: If a RAID controller or adapter is installed, you might have to reconfigure the
disk arrays after you install or remove hard disk drives. See the documentation that
comes with the adapter for more information.
Removing a simple-swap Serial ATA (SATA) hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To remove a simple-swap SATA drive from the bay, complete the following steps.
Hard disk
drive assembly
1. Read the safety information that begins on page vii and the "Installation
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the filler panel from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray out of the
144
IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide
Attention:
When you install an adapter, make sure that the adapter is
correctly seated in the riser-card assembly and that the riser-card assembly is
securely seated in the riser-card connectors on the system board before you
turn on the server. An incorrectly seated adapter might cause damage to the
system board, the riser-card assembly, or the adapter.
To avoid damage to the hard disk drive connectors, make sure that the
Simple-swap hard disk drives are not hot-swappable. Disconnect all
guidelines" on page 127.
all external cables.
bay.
SATA hard disk
drive back plate
Filler panel
Hide quick links:
Advertisement
Table of Contents
