hit counter script

Removing And Replacing Frus; Removing An Ibm Serveraid-Br10Il Sas/Sata Controller V2 - IBM x3250 M3 Problem Determination And Service Manual

Hide thumbs Also See for x3250 M3:
Table of Contents

Advertisement

Removing and replacing FRUs

FRUs must be replaced or installed only by trained service technicians.
The illustrations in this document might differ slightly from the hardware.

Removing an IBM ServeRAID-BR10il SAS/SATA Controller v2

To remove an IBM ServeRAID-BR10il SAS/SATA Controller v2 from the system
board, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 130).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on
5. Squeeze the tabs on both sides of the connector on the signal cable and
6. Carefully disengage the tabs on each side of the SAS/SATA adapter connector
7. Grasp the edges of the SAS/SATA adapter and pull it out of the connector.
8. If you are instructed to return the SAS/SATA adapter, follow all packaging
182
IBM System x3250 M3 Types 4251, 4252, and 4261: Problem Determination and Service Guide
on page 127.
Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power source is
removed. Before you disconnect the power source, make a note of which LEDs
are lit, including the LEDs that are lit on the operation information panel and
LEDs inside the server on the system board.
page 133).
remove the cable from the SAS/SATA adapter.
and the front of the SAS/SATA adapter from the retention bracket. Grasp the
SAS/SATA adapter near the end next to the heat sink while you press the
plastic tab (next to the heat sink) toward the heat sink.
instructions, and use any packaging materials for shipping that are supplied to
you.

Advertisement

Table of Contents
loading

Table of Contents