IBM x3250 M3 Problem Determination And Service Manual page 181
Hide thumbs
Also See for x3250 M3:
- Installation and user manual (102 pages) ,
- Product manual (37 pages) ,
- Manual (32 pages)
Table of Contents
Advertisement
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
Attention:
To avoid breaking the retaining clips or damaging the
ServeRAID-MR10is VAULT SAS/SATA adapter connector, open and close the
clips gently.
3. Remove the cover (see "Removing the cover" on page 130).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on
page 133).
5. Remove the expansion-slot cover on the slot that you intend to use and save
for future use.
Attention:
v To ensure proper cooling and airflow, install a ServeRAID adapter that has a
battery attached in slot 2 on the riser-card assembly.
v PCI expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the server and ensures
proper ventilation of server components.
6. Touch the static-protective package that contains the new ServeRAID-MR10is
VAULT SAS/SATA adapter to any unpainted surface on the outside of the
server; then, grasp the adapter by the top edge or upper corners of the
adapter and remove it from the package.
7. If the battery pack (battery carrier and battery) did not come installed on the
ServeRAID adapter, install the battery pack:
a. Align the battery carrier pins and the connector for the battery carrier with
the pin holes and connector on the ServeRAID adapter; then, lower the
battery carrier onto the ServeRAID adapter.
b. Press the battery carrier into the connector on the ServeRAID adapter until
it is firmly connected.
c. Secure the battery carrier to the ServeRAID adapter with the screws that
came with the battery pack.
8. Take the signal cable that is attached to the drive backplane and connect it to
the ServeRAID adapter. The following illustration shows the connectors on the
controller to which you connect the signal cable from the drive backplane.
Chapter 5. Removing and replacing server components
163
Hide quick links:
Advertisement
Table of Contents
