Clock Summer-Time - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
9
231
if the command is executed twice, each time with a different clock source, both
sources will be operational, SNTP has higher priority than time from browser.
Example
The following example configures an SNTP server as an external time source for
the system clock.
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)# exit
switchxxxxxx# show clock
*10:46:48 UTC May 28 2013
Time source is sntp
Time from Browser is enabled
9.5
clock summer-time
To configure the system to automatically switch to summer time (Daylight Saving
Time), use the clock summer-time command in Global Configuration mode. To
restore the default configuration, use the no form of this command.
Syntax
zone
clock summer-time
month hh:mm
offset
}} [
zone
clock summer-time
offset
[
]
zone
clock summer-time
[
offset
]
no clock summer-time
Parameters
•
zone
—The acronym of the time zone to be displayed when summer time is
in effect. (Range: up to 4 characters)
clock source sntp
clock source browser
|
recurring {usa
eu
]
day month year hh:mm date month year hh:mm
date
month day year hh:mm month day year hh:mm
date
OL-32830-01 Command Line Interface Reference Guide
|
week day month hh:mm week day
{
Clock Commands
Advertisement
Table of Contents
